Tailor Welded Blanks
Coil Welds in Mill Finishing Lines
Thin Butt Welds - Less than 12mm
Flash-Butt Welds in Steel Mills
In-Line ERW Tube Inspection
Submerged Arc Weld Pipe Inspection
Tube Girth Welds
Inspection of Multi-Pass Welds
Inspection of Surfaces
Laminated Metallic Strip
Surface Inspection on Ingots, Plates, Strip
Surface Inspection on Billets and Tubes
Small Diameter Tube and Rod Inspection
Inspection of Composites
Plates - Tubes - Structures
Bars and Tubes
Tube, Strip and Plate (EMAT)
Tube, Strip and Plate (DCUT)
Mill Roll Inspection
Inspection of Bridges
Electrical Conductivity Measurement
Bolt Load Measurement
Micro Structural Health Monitoring
Structural Monitoring System
Outdoor Remote On-Line Monitoring
Transformer Testing System
Inspection of Tubes, Bars, Structures, Immersion Tanks
Fully automated systems for volumetric inspection of plates, tubes, and other structures using conventional UT and EMAT
Bars and Tubes Inspection
Conventional and Phased Array ultrasonic inspection of ferrous and non-ferrous bars and tubes.
Plates (EMAT) Inspection
Normal beam inspection of thick plates. Ideally suited for inspection at high or very low temperatures.
Plates UT/PA Inspection
Conventional and Phased Array ultrasonic inspection of ferrous and non-ferrous plates.
Complete volumetric inspection of flange and web for large section I beams.
Immersion Tanks Inspection
High performance immersion tanks for unique Ultrasonic and Phased Array inspections.