Flat products (non-ferrous)

Flash-Butt Welds in Steel Mills (EMAT)
Flash-Butt Welds in Steel Mills (EMAT)
Weld inspection in pickle lines without additional cycle time. Detects defects caused by misalignment, poor trimming, and welder failures.
Learn More
Defect Detection in Plates (UT)
Defect Detection in Plates (UT)
Conventional and Phased Array ultrasonic inspection of ferrous and non-ferrous plates.
Learn More
Conductivity Measurement in Plates (EC)
Conductivity Measurement in Plates (EC)
Automated Electrical Conductivity Measurement System for Plates.
Learn More
Laminated Metallic Strip (EMAT)
Laminated Metallic Strip (EMAT)
Volumetric inspection of laminated strip for coin stock, bearings and similar multi-layered materials.
Learn More
Surface Inspection on Plates, Slabs, Ingots (EMAT)
Surface Inspection on Plates, Slabs, Ingots (EMAT)
Uses ultrasonic surface waves for automatic surface inspection of ferrous and non-ferrous flat products.
Learn More
Mill Rolls
Mill Rolls
Complete roll inspection including surface, sub-surface, core-shell disbond and bruise inspection using a proprietary technique.
Learn More
Stress Measurement (EMAT)
Stress Measurement (EMAT)
Stress measurement on railroad wheels, pipelines and plates.
Learn More
Thin Material Inspection
Guided wave technique used to inspect thin materials such as aircraft skin and thin, laminated composites, from 0.5mm (0.020") to 6mm (0.25").
LEarn More
Surface Inspections
Fast inspection for detection of surface defects on most metallic materials.
LEarn More
Thickness Measurement
EMAT sensors permit non-contact and no-couplant measurements from -30ºC to 650ºC on most metallic materials. DCUT sensors provide no-couplant measurements for metallic and non-metallic components.
LEarn More
Stress Measurement
Stress measurement on railroad wheels, pipelines and plates.
LEarn More