NDT for Oil & Gas Industry

Thin Butt Welds - Less than 6mm (EMAT)
Thin Butt Welds - Less than 6mm (EMAT)
TEMATE SI-BW is designed for inspection of thin butt welds less than 12mm.
LEarn More
In-Line ERW Tubes (EMAT)
In-Line ERW Tubes (EMAT)
Weld inspection for longitudinal ERW pipe immediately after welding.
LEarn More
ERW and SAW Tube and Pipe (PAUT)
ERW and SAW Tube and Pipe (PAUT)
Ultrasonic Phased Array inspection of linear welds on SAW and ERW pipes and tubes.
LEarn More
Inspection of Multi-Pass Welds (EMAT)
Inspection of Multi-Pass Welds (EMAT)
Ultrasonic inspection of multi-pass welds after each welding pass at temperature up to 200⁰C.
LEarn More
Surface Inspection on Billets and Tubes (EMAT)
Surface Inspection on Billets and Tubes (EMAT)
Provides surface and near-surface inspection of long products (round, square and tubes). Better accuracy than MFL at a fraction of the cost.
LEarn More
Stress Measurement (EMAT)
Stress Measurement (EMAT)
Stress measurement on railroad wheels, pipelines and plates.
LEarn More
Bolt Load Measurement (EMAT)
Bolt Load Measurement (EMAT)
Bolt-load measurement without couplant.
LEarn More
Light-Coated Free Standing Pipe Inspection
Uses axial scanning of free standing pipes with none or light coatings (<3-4mm) for fast and accurate defect detection around the circumference.
LEarn More
Corrosion Under Pipe Support Inspection
Uses axial scanning to find corrosion under supports when the pipe is accessible from the top.
LEarn More
Inaccessible Area Inspection
Side –circumferential- scanning is used for detection of defects on inaccessible areas up to 3m (10’) from the sensor.
LEarn More
Tank Volumetric Inspection
Fast plate and tank inspection covering up to 1m (3’) per pass.
LEarn More
Surface Inspections
Fast inspection for detection of surface defects on most metallic materials.
LEarn More
LRUT (Long Range UT)
LRUT provides inspection of long range of pipes up to 100m for a faster screening of large distances of pipes.
LEarn More
Thickness Measurement
EMAT sensors permit non-contact and no-couplant measurements from -30ºC to 650ºC on most metallic materials. DCUT sensors provide no-couplant measurements for metallic and non-metallic components.
LEarn More
Bolt Load Inspection
Bolt load inspection without couplant.
LEarn More
Boiler Inspection
Thickness measurement of boiler tube walls, HCC detection.
LEarn More
Stress Measurement
Stress measurement on railroad wheels, pipelines and plates.
LEarn More