Flat Products (Ferrous)

Coil Welds in Mill Finishing Lines (EMAT)
Coil Welds in Mill Finishing Lines (EMAT)
The TEMATE SI-MWC and TEMATE SI-LC are designed for automated inspection of Mash Welds and Laser Welds.
Learn More
Thin Butt Welds - Less than 6mm (EMAT)
Thin Butt Welds - Less than 6mm (EMAT)
TEMATE SI-BW is designed for inspection of thin butt welds less than 12mm.
Learn More
Flash-Butt Welds in Steel Mills (EMAT)
Flash-Butt Welds in Steel Mills (EMAT)
Weld inspection in pickle lines without additional cycle time. Detects defects caused by misalignment, poor trimming, and welder failures.
Learn More
Defect Detection in Plates (UT)
Defect Detection in Plates (UT)
Conventional and Phased Array ultrasonic inspection of ferrous and non-ferrous plates.
Learn More
Surface Inspection on Plates, Slabs, Ingots (EMAT)
Surface Inspection on Plates, Slabs, Ingots (EMAT)
Uses ultrasonic surface waves for automatic surface inspection of ferrous and non-ferrous flat products.
Learn More
Mill Rolls
Mill Rolls
Complete roll inspection including surface, sub-surface, core-shell disbond and bruise inspection using a proprietary technique.
Learn More
Stress Measurement (EMAT)
Stress Measurement (EMAT)
Stress measurement on railroad wheels, pipelines and plates.
Learn More
Thin Material Inspection
Guided wave technique used to inspect thin materials such as aircraft skin and thin, laminated composites, from 0.5mm (0.020") to 6mm (0.25").
LEarn More
Surface Inspections
Fast inspection for detection of surface defects on most metallic materials.
LEarn More
Thickness Measurement
EMAT sensors permit non-contact and no-couplant measurements from -30ºC to 650ºC on most metallic materials. DCUT sensors provide no-couplant measurements for metallic and non-metallic components.
LEarn More
Stress Measurement
Stress measurement on railroad wheels, pipelines and plates.
LEarn More