< Back

NDT for Aerospace industry

THIN WELDS (<6mm) (EMAT)
THIN WELDS (<6mm) (EMAT)
TEMATE SI-BW is designed for inspection of thin butt welds less than 12mm.
Learn More
MULTI-PASS WELDS, INSPECTION WHILE WELDING IWW (EMAT)
MULTI-PASS WELDS, INSPECTION WHILE WELDING IWW (EMAT)
Ultrasonic inspection of multi-pass welds after each welding pass at temperature up to 200⁰C.
Learn More
CAMUS 3D - SEMI-AUTOMATED
CAMUS 3D - SEMI-AUTOMATED
Semi-automated camera-encoded cells designed for inspection of composite parts when an automated system isn’t practical and manual inspections are too time consuming.
Learn More
TAURUS - AUTOMATED
TAURUS - AUTOMATED
Automated robotic systems designed for inspection of large composite parts and forgings.
Learn More
CONDUCTIVITY MEASUREMENT IN PLATES (EC) AUTOMATED
CONDUCTIVITY MEASUREMENT IN PLATES (EC) AUTOMATED
Automated Electrical Conductivity Measurement System for Plates.
Learn More
LAMINATED METALLIC STRIP (EMAT)
LAMINATED METALLIC STRIP (EMAT)
Volumetric inspection of laminated strip for coin stock, bearings and similar multi-layered materials.
Learn More
SURFACE INSPECTION, ON PLATES, INGOTS (EMAT)
SURFACE INSPECTION, ON PLATES, INGOTS (EMAT)
Uses ultrasonic surface waves for automatic surface inspection of ferrous and non-ferrous flat products.
Learn More
SMALL DIAMETER TUBE AND ROD (EMAT)
SMALL DIAMETER TUBE AND ROD (EMAT)
Full volumetric inspection of rods. Detects longitudinal defects and inclusions. Well suited for copper, steel and other metals.
Learn More
IMMERSION TANKS (UT, PAUT)
IMMERSION TANKS (UT, PAUT)
High performance immersion tanks for unique Ultrasonic and Phased Array inspections.
Learn More
SURFACE INSPECTION (EMAT)
Fast inspection for detection of surface defects on most metallic materials.
LEarn More
Thickness Measurement and Flaw Detection (EMAT, DCUT)
EMAT sensors permit non-contact and no-couplant measurements from -30ºC to 650ºC on most metallic materials. DCUT sensors provide no-couplant measurements for metallic and non-metallic components.
LEarn More
Bolt Load Inspection (EMAT)
Measurement of bolt-load by comparing variations in ultrasonic Time-Of-Flight corresponding to changes in bolt elongation (strain). Single (SH) wave and double (SH + L) wave sensors available to meet different requirements.
LEarn More
Stress Measurement (EMAT)
Residual stress measurement on railroad wheels, pipelines, and steel plates using custom sensors, software, and positioners.
LEarn More