< Back

MRUT - Medium Range UT (EMAT)

MRUT describes a suite of techniques that permit inspecting an area between approximately 25mm to 3m from the location where the inspection is performed. MRUT can be performed on pipes, plates, rods, and components with irregular geometries. MRUT complements LRUT (Long Range UT) by covering the near field area where LRUT cannot be used with much higher resolution and detection capabilities.

Light-Coated Free Standing Pipe Inspection
Light-Coated Free Standing Pipe Inspection
Uses axial scanning on free-standing pipes with none or light coatings (<3-4mm) for fast and accurate defect detection around the circumference of the pipe.
LEarn More
Corrosion Under Pipe Support (CUPS)
Corrosion Under Pipe Support (CUPS)
Axial and/or Circumferential scanning to detect and measure corrosion under pipe supports.
LEarn More
Inaccessible Area Inspection
Inaccessible Area Inspection
Side inspection is used for the detection of defects in inaccessible areas up to 3m (10’) from the sensor.
LEarn More